7/8/2023 0 Comments Pci video controllerOn some drives, the jumper diagram is on the label that is on the top of the drive. There is no standard position for the jumpers on IDE drives. If Master is not working, try using the drive in Cable Select. When it does not mention what IDE drive configuration is required or if there is only one drive in the setup, the drive should be configured as Master. A jumper is a small plastic piece that slides on top of two pins to electrically short them together. The jumpers switch the drive between Master, Slave, and Cable Select for most drives. If you are unable to detect your IDE (PATA) drive using a product, you may need to change the jumper settings on your drive. Note: If you are using an IDE hard drive 1 Gigabyte in size or smaller, refer to the following FAQ:
0 Comments
Leave a Reply. |